Calculators

Deck Board Calculator

Estimate how many deck boards, joists and screws a deck takes, using standard US lumber sizes and an allowance for cuts.

How many deck boards do I need?

Enter the deck length (the direction the boards run) and width in feet, pick your board size and length, then press Calculate.

Results are estimates for planning, and any prices are rough US ranges. Bag sizes, material weights and prices vary by supplier and region - confirm the final quantity before you order.

Good to know

Planning your deck

A few pointers so the boards go down straight and your lumber order is right the first time.

Board gaps

Leave about ⅛ in between boards for drainage. Wet pressure-treated boards can go down tight - they shrink as they dry. Follow the maker’s spacing for composite.

Joists at 16 in on center

Most decks use 2×8 or 2×10 joists at 16 in on center. Composite boards and diagonal layouts often need 12 in.

Order extra

Add about 10% for cut ends and the odd crooked or split board, more for picture-frame borders or angles.

For your deck build

Our picks

As an Amazon Associate, PlantMapper may earn from qualifying purchases. Prices and availability are set by Amazon.

← All garden calculators

Common questions

How many deck boards do I need for a 12 × 12 deck?

With 5½-inch boards and a ⅛-inch gap, each board covers about 5⅝ inches of width, so a 12 ft wide deck takes 26 rows. If the boards run the full 12 ft, that is 26 twelve-foot boards, or 29 with about 10% for waste. The calculator does this for any size and board length.

Do I need a permit to build a deck?

Often, yes. Under the International Residential Code, which most US towns adopt, a deck can be exempt only if it is under 200 square feet, no more than 30 inches above grade, not attached to the house and not serving a required exit door. Many localities and HOAs set their own rules, so check with your building department before you buy lumber.

What size joists and spacing should a deck have?

Joists are usually 2×8 or 2×10 at 16 inches on center; the size depends on how far they span between beams and on the lumber species. Composite and PVC boards commonly call for 12 inches on center, as do diagonal board layouts. Use the span tables your building department follows, and protect joist tops with butyl tape for a longer life.

Is pressure-treated wood or composite decking better?

Pressure-treated pine is the cheapest to buy and easy to work, but it needs cleaning and sealing every couple of years and can check and warp. Cedar and redwood look beautiful and resist rot naturally at a higher price. Composite and PVC cost more up front but need little upkeep and don’t splinter. All of them need a sound, properly spaced frame.

More in Calculators

See everything in Calculators →